Elo Touch Solution X7-17 User Manual download pdf (Page 45)

User Manual: X-Series Rev A AiO Touchcomputer

SW602213 Rev A, Page 45 of 51

Chapter 7: Regulatory Information

I. Electrical Safety Information

Compliance is required with respect to the voltage, frequency, and current requirements

indicated on the manufacturer label. Connection to a different power source than those

specified herein will likely result in improper operation, damage to the equipment or pose a fire

hazard if the limitations are not followed.

There are no operator serviceable parts inside this equipment. There are hazardous voltages

generated by this equipment which constitute a safety hazard. Service should be provided only

by a qualified service technician.

Contact a qualified electrician or the manufacturer if there are questions about the installation

prior to connecting the equipment to mains power.

II. Emissions and Immunity Information

Notice to Users in the United States:

This device complies with part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1) This device may not cause harmful interference, and (2) this device must accept

any interference received, including interference that may cause undesired operation.

Note: This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates,

uses, and can radiate radio frequency energy and, if not installed and used in accordance with

the instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which can be determined by turning

the equipment off and on, the user is encouraged to try to correct the interference by one or

more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment to an outlet on a circuit different from that to which the receiver is

connected.

- Consult the dealer or an experienced radio/TV technician for help.

Caution: Any changes or modifications not expressly approved by the party responsible for

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 51

No comments

Elo Touch Solution X7-17 User Manual Page 45